Case Study Questions for Class 11 Physics Chapter 11 Thermal Properties of Matter

  • Last modified on:3 years ago
  • Reading Time:5Minutes
Home CBSE Class 11 Physics Case Study Qs Case Study Questions for Class 11 Physics Chapter 11 Thermal Properties of Matter

Case Study Questions for Class 11 Physics Chapter 11 Thermal Properties of Matter

Case Study Questions:

Question 1:

Specific Heat Capacity

Heat capacity of a substance is defined as

where ΔQ is the amount of heat supplied to the substance to change its temperature from T to T + ΔT.

Specific heat capacity is the amount of heat per unit mass absorbed or given off to change its temperature by one unit.

It depends on the nature of substance and its temperature.

1. Which one of the following substances has highest specific heat capacity at room temperature and atmospheric pressure?

(a) Water

(b) Ice

(c) Aluminium

(d) Mercury

2. Heat capacity of a substance is infinite. It means

(a) heat is given out.

(b) heat is taken in.

(c) no change in temperature whether heat is taken in or given out.

(d) all of these.

3. Water is used as a coolant because

(a) it has lower density.

(b) it has low specific heat.

(c) it has high specific heat.

(d) it is easily available.

4. Calorie is defined as the amount of heat required to raise the temperature of 1 g of water by 1°C and it is defined under which of the following conditions?

(a) From 14.5°C to 15.5°C at 760 mm of Hg

(b) From 98.5°C to 99.5°C at 760 mm of Hg

(c) From 13.5°C to 14.5°C at 76 mm of Hg

(d) From 3.5°C to 4.5°C at 76 mm of Hg

5. Find the thermal capacity of 40 g of aluminum. (s = 0.2 cal/g K)

(a) 168 J/°C

(b) 672 J/°C

(c) 840 J/°C

(d) 33.6 J/°C


Answer

➤ Show Answer Answer:
1. (a)
2. (c) : Infinite thermal capacity implies that there would be practically no change in temperature whether heat is taken in or given out.
3. (c) : Owing to its high specific heat, water is used as a coolant in automobile radiators as well as a heater in hot water bags.
4. (a) : 1 calorie is the amount of heat required to raise the temperature of 1 g of water from 14.5°C to 15.5°C at 760 mm of Hg.
5. (d)

Related Posts

You May Also Like:

Category Lists (All Posts)

Select Category

All categories of this website are listed below with number of posts in each category for better navigation. Visitors can click on a particular category to see all posts related to that category.

Test Series (Engineering, Medical and School Level Exams)

Test series for students preparing for Engineering & Medical Entrance Exams are available. We also provide test series for School Level Exams. Tests for students studying in CBSE, ICSE or any state board are available here. Just click on the link and start test.

Leave a Reply

Join Telegram Channel

Editable Study Materials for Your Institute - CBSE, ICSE, State Boards (Maharashtra & Karnataka), JEE, NEET, FOUNDATION, OLYMPIADS, PPTs

Discover more from Gurukul of Excellence

Subscribe now to keep reading and get access to the full archive.

Continue reading